Generally, the dicing blade is made of synthetic resin, copper, tin, nickel and so on, which are combined with artificial diamond as binder. It is mainly divided into two categories: hard cutter with wheel hub and integral cutter without wheel hub. It is suitable for processing chips and semiconducting materials of different types.

Turning finishing method:

The single point diamond dressing tools installed on the tool rest usually inclines about 5°~15° in both vertical and horizontal directions, the contact point between the diamond dressing tools and grinding wheel should be 0.5~2 mm lower than the axis of grinding wheel, and the diamond dressing tools should move evenly at low speed during dressing.

After grinding, the workpiece surface roughness Ra<0.01m, the light like mirror, can be clearly imaging, so it is called mirror grinding. The flatness of the grinding surface is not greater than 3m/1000mm. Surface grinding of high precision and high added value parts is required.

Ultra-high strength steel is a kind of alloy steel used to make structural parts under high stress. General flexural strength is greater than 1180MPa, tensile strength is greater than 1380MPa this kind of steel generally has enough toughness and high specific strength and flexural ratio, and good weldability and formability. According to alloying degree and microstructure, it can be divided into low alloy, medium alloy and high alloy ultra-high strength steels. When grinding ultra-high strength steel, the grinding force, grinding temperature and grinding surface quality of workpiece will be greatly affected by the grinding amount. Increasing the grinding wheel speed can decrease the grinding force but increase the grinding temperature.

The CIOE 2021 held in shenzhen international convention and exhibition center on September 16, 2021. MoreSuperhard Products Co.,Ltd was invited to participate in this exhibition, our booth: 5E81. Moresuperhard has rich diamond production experience more than 15 years.

The lubrication effect of the grinding fluid is good, which can protect the grinding wheel and the workpiece at the same time, reduce the resistance during grinding, improve the processing efficiency and the surface quality of the workpiece. Good lubrication effect is also shown in good chip separation effect, that is, it plays a lubricating role, but the chip is not easy to bond to the workpiece or grinding wheel surface, the separation effect is good. At the same time, the general grinding fluid is alkaline, and its PH value must be strictly controlled (generally 9~10, not more than 11). If the alkalinity is too strong, it will neutralize and corrode the acidic resin grinding wheel, soften the grinding wheel, and reduce the service life of the grinding wheel.